-
The system has the ability to operate four different modes of application: Flare, Flare Plus, Igniter and BMS.
-
Use the system to monitor and control up to two temperature set-points.
-
A USB port enables you to capture important data to a memory stick.
FEATURES:
-
4 operational modes (see Specifications)
-
Temperature control – up to 2 thermocouples
-
Very low power consumption
-
Built-in charge controller for solar & line power with battery backup applications
-
Time and date stamped event record log
-
USB port to capture internal data
-
Automatic restart after a power failure
-
Mix and match solenoid drives
-
Selectable status output
-
Optional Thermocouple input for flame detection
-
Internal watchdog system
-
User-friendly setup and operation
-
Ultra bright LED status indicators
-
Password protection secures interface from tampering
SPECIFICATIONS:
| GAS SERVICE TYPE: | Natural gas or propane |
| OPERATIONAL MODES: |
Flare: Ignition control Flare+: Ignition control & pilot solenoid control Igniter: Ignition control & up to 3 solenoid control BMS: Ignition control. up to 3 solenoid control and up to 2 temperature control |
| MAX # IGNITION ATTEMPTS: |
Flare & Flare+: Infinite, as needed Igniter & BMS: 3 before shutdown |
| POWER REQUIREMENTS (12/24V): | 0.20W (Unit operating in flare mode, run status, no solenoids) |
|
TEMPERATURE RATING: |
-40°F to 131°F -40°C to 55°C |
|
TEMPERATURE DEVICE: |
Up to 2 type-k thermocouples |
| SOLENOID DRIVES (12/24V): |
Single-coil -Dual-coil latching -Peak & hold |
| STATUS OUTPUT: | Programmable – running, pilot or ESD |
|
BATTERY (Optional): |
12V sealed lead-acid, Main enclosure will house up to 14AH battery |
| CERTIFICATIONS: |
Class I, Division 2 C22.2 No. 0-10 ANSI Z21.20 - 2014 CAN/CSA C22.2 No. 60730-2-5-2014 |
